Operation Manual
English
5
scala rider
®
Solo
™
4. After a few seconds the phone will list the scala-rider
as a discovered device. Select it and follow your phone’s
instructions to accept the pairing.
5. When prompted enter 0000 (four zeros) as your PIN or passkey.
6. Your phone will conrm that pairing has succeeded and the
headset will begin ashing slowly in Blue.
NOTE: If the Pairing process is not completed within two minutes the
headset will return to Standby mode.
With some mobile phones, you may need to tap the CTRL button
to connect the headset to the phone after pairing is complete. The
scala rider Solo headset will automatically connect to the last phone
connected to the headset.
SET UP FOR BLUETOOTH GPS DEVICE
If you have a Bluetooth enabled GPS device and would
like to transmit navigation instructions and sounds from
the GPS device through the headset’s speakers, please
follow instructions described in section below “TO PAIR
THE SCALA RIDER SOLO TO A BLUETOOTH GPS DEVICE”
If you want to use your mobile phone and your GPS device with the
scala rider Solo headset, you should proceed as follows:
1. Pair your GPS device to your mobile phone (Please consult your
GPS device’s User Manual for more information).
2. Pair your headset to the GPS device as described below.
NOTE: Not all Bluetooth enabled GPS devices allow connections to
Bluetooth headsets like the scala rider Solo. Please consult your GPS
device’s User Manual for more information.
TO PAIR THE SCALA RIDER SOLO TO A BLUETOOTH GPS DEVICE:
1. Turn on your GPS device.
2. With the scala rider Solo headset turned OFF, press and hold
the CTRL Button until the Red and Blue Lights begin rapidly
alternating.
3. Search for Bluetooth headsets on your GPS device by following
the device’s instructions. Please consult your GPS device’s User
Manual for more information.
4. If your GPS device prompts for a PIN or Passkey enter 0000 (four
zeros).
5. Your GPS device will conrm that pairing has succeeded. The
headset will begin ashing slowly in Blue.
6. If you wish to use a Bluetooth mobile phone to make and
receive calls through the headset, you must now pair your
mobile phone to your GPS device by following your GPS and/or
mobile phone’s instructions.
NOTE: If the Pairing process is not completed within two
minutes the headset will return to Standby mode.
ATTACHING THE CLAMP ON THE HELMET
The Helmet Clamp must be attached to the left side of the helmet. Once
attached, the headset unit can be mounted or released from the Helmet
Clamp at any time. If you wish to connect your MP3 player to your head-
set, please refer rst to the assembly instructions listed in section: USING
THE MP3 PLAYER WITH YOUR HEADSET.
There are two methods that can be used in order to attach the Clamp
onto the helmet:
Standard Method: Recommended for most helmet types.
Glue Plate Method: Recommended for helmets
to which the standard method cannot be
applied, using the Glue Plate included in the
box.