Specifications

Installation & Maintenance Manual__________
34
To display the regulation parameters and the
measurements
you must:
1. Press the PRG button for about 5 seconds until
the digits P0 appear, representing the first
parameter.
2. Press the buttons ∆ or ∇ to cycle through the
parameters Px and dx, including the Set Point;
3. Press the SEL button to display the value of the
selected parameter; the unit of measure will also
be displayed for one second;
4. Press the PRG button to terminate the
parameter display.
To modify the regulation parameters (the
measurements can only be displayed) do the
following:
1. Press the PRG button for 5 seconds until the
digits P0 appear, representing the first
parameter.
2. Press the buttons ∆ or ∇ to cycle through the
parameters P and d, including the Set Point;
3. Press the SEL button to display the value of the
parameter selected; the unit of measure will also
be displayed for one second;
4. Press the buttons ∆ or ∇ to modify the value.
Hold down the button to increase the speed of
the change.
5. Press the SEL button to move to the next value
displayed; the code P or d;
6. You can display and alter the subsequent
parameters by repeating steps 2 through 5;
7. Press the PRG button to place your changes
into effect and to terminate the parameter
display.
3 - Press SEL to display
the value of the
parameter selected
5 – Press SEL to display the
value of the selected
parameter
7 - Press PRG to place the new
values into memory
4 – Press repeatedly to modify the value of the
parameter
6 – Repeatedly press to access
subsequent parameters
1 – Press PRG for 5 seconds
until P0 appears
2 – Press repeatedly to scroll
through the parameters
and measurements
1 - Press PRG for 5 seconds
until P0 appears
2 – Press repeatedly to scroll
through the parameters
3 - Press SEL to display the
value of the parameter
selected