User's Guide

Working with the Media and Ink
2012-01-27 9G4260_en 2-11
2. Slide the output tray to the second and third extensions.
NOTE: Do not raise the flap. If the flap is raised while printing from the
roll feeder (for example, if No Cut is selected), the paper might
eject incorrectly.
3. Set up the paper eject support depending on the paper type.
4. Check that the Media Source setting is set to Roll Paper/Cut.
NOTE: The Roll Paper/Cut setting supports printing to both roll paper
and to cut sheets in the media cassette.
To change the Media Source setting:
• Press to display the Paper Type Menu.
• Press to select Roll Paper/Cut.
• Press OK.
Cutting the Roll Paper After printing, the paper is cut automatically.
NOTE: If the roll paper cannot be cut by the built-in cutter, press to
feed the paper to a position where you can cut it manually.
Roll Paper/Cut
SHORT TERM CONFIDENTIAL