User's Manual

2-6 9G3886_en 2011-03-31
Basic Operating Tasks
Inserting a new film
cartridge
Before you insert a new film cartridge, make sure that the Pause symbol
is off. During normal operation, the symbol is off. When the film
cartridge cover is open, the symbol is on. To avoid exposing the film to
light, do not open the film supply until the Pause symbol is off.
If the Pause symbol is on, press the symbol to close the film cartridge
cover.
1. Open the film supply. Hold the edges of the film cartridge and lift
the empty cartridge out of the film supply.
2. Discard the removed cartridge.
3. Insert the new film cartridge. Align the cartridge with the label
facing up and the perforations to the front. Set the leading edge on
the cartridge guides, and then slide the film cartridge into the laser
imager to engage the detents in the bottom of the cartridge.
4. Close the film supply.
5. Check that the display screen changes to reflect the new film count.
Make sure the Pause symbol is off (not illuminated)
before you insert a new film cartridge.
Pause symbol is on
Pause symbol is off
H210_1020AC
H210_1020ACA
Leading Edge
Detents
Perforations
Cartridge
Guide
Film Supply