User's Manual

2-8 9G3886_en 2011-03-31
Basic Operating Tasks
Deleting pending jobs
To cancel all print requests, press and hold the Film Size symbol for five
seconds. All print requests are deleted from the queue.
NOTE:
• A print request that cannot be printed is automatically deleted
from the laser imager. This situation could be caused by
invalid parameters from the modality, etc.
• If a job is not printable, the laser printer
will eject a blank
film into the exit tray
.
Making a test print
NOTE: You can make additional test prints at the Web Portal. For more
information, see “Accessing the Web Portal” on page 2-10.
Make a SMPTE test from the laser imager to check that you can print.
Press and then release the Calibration and Pause symbols. The symbols
flash until the test print is complete.
Press this symbol
for five seconds
Press these
two symbols at
the same time
for five
seconds