User's Manual
Table Of Contents
- 1 Overview
- Major internal assemblies
- How the laser imager works
- Print sequence
- Film sizes
- Automatic image quality and processing
- Configuring and monitoring the system (using the Web Portal)
- Enhancing serviceability with remote monitoring
- Agency compliance
- User guide conventions
- 2 Basic Operating Tasks
- Understanding the display screen
- Turning the power on and off
- Emergency shutdown or power loss
- Restarting the laser imager
- Working with film cartridges
- Checking film count
- Checking the size of the loaded film
- Film count is flashing "0"
- Inserting a new film cartridge
- Loading a different film size to match a print request
- Deleting pending jobs
- Making a test print
- Calibrating the laser imager for the installed film
- Opening or removing a cover
- Using the Web Portal to access additional functionality
- Accessing the Web Portal
- 3 Maintenance and Troubleshooting
- Overview: Status and error messages and codes
- Preventive maintenance
- Replacing the filter
- 550 code and Maintenance symbol
- Error indicators on the display screen
- Calibration error
- Required restart
- Film jams
- Using the Web Portal to gain more information on errors
- Understanding the codes on the Web Portal and the Display Screen
- Subsystem error codes and messages
- DICOM (Digital Imaging and Communications in Medicine)
- Printer
- Film Cartridge
- Job Manager
- Condition codes
- Correcting film jams
- Film jam code 116 / Jam in Area 1
- Film jam code 323 / Jam in Area 2
- Film jam code 324 or 325 / Jam in Area 2
- Film jam code 326 / Jam in Area 2 or 3
- Film jam code 543 / Jam in Area 3
- Film jam code 544 / Jam in Area 3
- Display Screen is not functional
- Calling for support
- 4 Film Technical Information
- General description
- Spectral sensitivity
- Image quality
- Environmental impact
- Storing and handling undeveloped film
- Dissipating odor
- Recycling film
- 5 Specifications
- Equipment specifications
- Operating space requirements
- Environmental requirements
- Temperature
- Relative humidity
- Altitude
- Surface levelness
- Environmental effects
- Power requirements
- Network requirements
- Publication History
3-16 9G3886_en 2011-03-31
Maintenance and Troubleshooting
Film jam code 323 /
Jam in Area 2
NOTE: This error displays as code 26323 at the Web Portal.
1. If the Pause symbol is on, press it and wait until it goes off.
2. Open the film supply.
3. Check that the film cartridge is closed. If it is not closed, carefully
close the cartridge cover.
4. Remove any loose film near, in, or partially in the film cartridge.
5. Close the film supply.
Film jam code 324 or
325 / Jam in Area 2
NOTE: This error displays as code 26324 or 26325 at the Web Portal.
1. If the Pause symbol is on, press it and wait until it goes off.
2. Remove the left cover:
a. Open the film supply.
b. Remove the top cover.
c. Turn the knurled knobs by hand.
3. Reach into Area 2 and remove any film. See page 3-14 for the film
jam areas.
4. If the film is not loose, carefully turn the exposure transport knob
clockwise to remove the film from the rollers. See page 3-15 for the
location of the knob.
5. Reinstall the covers.
H210_1017AC
H210_1017ACA
2 Screws
Remove the top
cover to gain
access
Open the film supply
to gain access
Left cover
2 Knurled knobs