User's Guide
Table Of Contents
- 1 Overview
- 2 Using and Maintaining the Imager
- 3 Troubleshooting
- 4 Film Technical Information
- 5 Specifications
- Glossary
- Appendix A: Warranty and Limitation of Liability
- Important Notice to Purchaser
- End User License Agreement (EULA)
- Carestream Health, Inc. Software End User License Agreement
- End-User License Agreement for Microsoft Desktop Operating Systems
- Software Product License
- Warranty/Special Provisions for Austria, New Zealand or Papua New Guinea - Express Limited Warranty
- Warranty/Special Provisions for England Scotland, Wales and Ireland - Limited Warranty
- Warranty/Special Provisions for Canada - Limited Warranty
- GARANTIE ET DISPOSITIONS PARTICULIÈRES POUR LE CANADA GARANTIE LIMITÉE
- Warranty/Special Provisions for the United States of America and any Other Country - Limited Warranty
January 14, 2008 2G0733 2-1
2 Using and Maintaining the
Imager
Operator Control of the Imager
During normal operation, the Imager receives and automatically prints
images sent by modalities over a network. Very little operator control is
required. The main responsibilities of the operator are:
Turning Imager Power ON and OFF
There is a power switch located at the back right of the Imager.
In the event of a power loss, the Imager shuts down. Films in process
will not be completed and will remain where they are located in the
Imager.
The Imager will restart after power is restored. After self-test, the
Imager clears any films in process and automatically reprints any films
that were in process when power was interrupted.
Power switch