User's Guide
Table Of Contents
- 1 Overview
- 2 Using and Maintaining the Imager
- 3 Troubleshooting
- 4 Film Technical Information
- 5 Specifications
- Glossary
- Appendix A: Warranty and Limitation of Liability
- Important Notice to Purchaser
- End User License Agreement (EULA)
- Carestream Health, Inc. Software End User License Agreement
- End-User License Agreement for Microsoft Desktop Operating Systems
- Software Product License
- Warranty/Special Provisions for Austria, New Zealand or Papua New Guinea - Express Limited Warranty
- Warranty/Special Provisions for England Scotland, Wales and Ireland - Limited Warranty
- Warranty/Special Provisions for Canada - Limited Warranty
- GARANTIE ET DISPOSITIONS PARTICULIÈRES POUR LE CANADA GARANTIE LIMITÉE
- Warranty/Special Provisions for the United States of America and any Other Country - Limited Warranty
2-2 2G0733 January 14, 2008
Using and Maintaining the Imager
Local Panel and Display Screen
Local Panel Layout
1 Ready LED. This LED, when lit indicates that the Imager is ready
for printing. When flashing, the Imager is processing and printing
films. When unlit, the Imager is not ready to print.
2 Error LED. When lit, this LED indicates that the Imager has an
error. An error code will appear on the display screen indicating
what the actual error is.
3 Attention LED. When lit, this LED indicates a condition that
requires attention, such as "out of film". The Imager can still
process and print films from unaffected film trays.
4 Warming LED. When lit, this LED indicates that the Imager is
warming up. A timer is also shown on the display screen indicating
the amount of time, in minutes, before the Imager reaches
operating temperature.
5 Display screen. Displays codes and icons that indicate the status
and operating condition of the Imager.
6 Maintenance Reset LED/Button. Pushing and holding the button
for 5 seconds displays a menu and allows the user to perform
various reset functions.
7 Unlock buttons. Used to unlock the film trays.
Note: The trays will not unlock unless a film saver is installed in
trays that have film.
8 Calibration buttons. Used to initiate a manual film calibration.
{
1
2
3
4
567
8