User's Guide
Table Of Contents
- 1 Overview
- 2 Using and Maintaining the Imager
- 3 Troubleshooting
- 4 Film Technical Information
- 5 Specifications
- Glossary
- Appendix A: Warranty and Limitation of Liability
- Important Notice to Purchaser
- End User License Agreement (EULA)
- Carestream Health, Inc. Software End User License Agreement
- End-User License Agreement for Microsoft Desktop Operating Systems
- Software Product License
- Warranty/Special Provisions for Austria, New Zealand or Papua New Guinea - Express Limited Warranty
- Warranty/Special Provisions for England Scotland, Wales and Ireland - Limited Warranty
- Warranty/Special Provisions for Canada - Limited Warranty
- GARANTIE ET DISPOSITIONS PARTICULIÈRES POUR LE CANADA GARANTIE LIMITÉE
- Warranty/Special Provisions for the United States of America and any Other Country - Limited Warranty
Troubleshooting
January 14, 2008 2G0733 3-11
27604 Optics: Calibration Failed 1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
27607 Optics: Calibration Failed 1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
27611 Optics: Internal Hardware
Failure
1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
27646 Optics: Internal Hardware
Failure
1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
27650 Optics: Internal Hardware
Failure
1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
27931 Optics: Internal Communications
Failure
1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
28154 Processor: Internal
Communications Failure
1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
28155 Processor: Internal
Communications Failure
1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
28501 Processor: Internal Hardware
Failure
1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
28509 Processor Warm-up Failure 1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
28510 Processor: Internal Hardware
Failure
1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
28551 Processor Heater Failure 1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
28554 Processor Over Temperature 1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
28931 Processor: Internal
Communications Failure
1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
29154 Densitometer: Internal
Communications Failure
1. Shut down the Imager, then start the Imager.
2. If the error persists, call for service.
Table 3-5: Condition Codes (Cont’d)
Code Web Portal Message User Action