User's Guide
Table Of Contents
- 1 Overview
- 2 Using and Maintaining the Imager
- 3 Troubleshooting
- 4 Film Technical Information
- 5 Specifications
- Glossary
- Appendix A: Warranty and Limitation of Liability
- Important Notice to Purchaser
- End User License Agreement (EULA)
- Carestream Health, Inc. Software End User License Agreement
- End-User License Agreement for Microsoft Desktop Operating Systems
- Software Product License
- Warranty/Special Provisions for Austria, New Zealand or Papua New Guinea - Express Limited Warranty
- Warranty/Special Provisions for England Scotland, Wales and Ireland - Limited Warranty
- Warranty/Special Provisions for Canada - Limited Warranty
- GARANTIE ET DISPOSITIONS PARTICULIÈRES POUR LE CANADA GARANTIE LIMITÉE
- Warranty/Special Provisions for the United States of America and any Other Country - Limited Warranty
Overview
January 14, 2008 2G0733 1-3
Print Sequence
When the Imager receives a print request, it determines the requested film
size and type and then it selects the appropriate film cartridge.
Each time the Imager receives a print request, the following print sequence
occurs:
1. Suction cups in the pickup area lift a single sheet of film out of the
supply cartridge and feed the film into the transport rollers.
2. The transport rollers move the film up into the registration transport
area, where film registration takes place.
3. The film registration transport then moves the film into the exposure
transport area.
4. As the film moves through the exposure transport, the optics module
writes the image onto the film, then moves the film into the film
processor.
5. As the film passes over the processor drum, the heat generated by the
drum develops the film.
6. The film transport rollers move the exposed film to the exit area.
1
2
3
4
5
6