User's Manual
Table Of Contents
- 2G8647_001.pdf
- 2G8647_002.pdf
- 2 Using and Maintaining the Imager
- Operator Control of the Imager
- Turning Imager Power ON and OFF
- Power ON
- Normal Power OFF
- Emergency Power OFF
- Power Failures
- Power Save
- Using the Touch Screen
- Touch Screen Functions
- Touch Screen Help
- General Help
- Specific Screen Help
- Installation Road Map
- Physical Setup
- Configuration
- Imager Passcode
- Loading and Removing the Film Cartridges
- Drawers and Doors
- Opening Film Drawers and Main Door
- Opening the Film Registration Door
- Opening Air Intake Door
- Film Drawers and Main Door Manual Override Latch
- Filter Maintenance
- Cleaning the Electronics Filter
- Changing the PMM
- 2G8647_003.pdf
- 2G8647_004.pdf
- 4 Adding a Modality and Configuring Modality Image Quality
- Introduction
- Adding a Modality
- Configuring Modalities Automatically
- Configuring Modalities Manually
- Configuring Modalities that use PLUTs
- Configuring Modalities that use TFT Sets and Contrast Tables
- Fine Tuning the Image with TFTs Sets and Contrast Tables
- Performing a Contrast Test
- 2G8647_005.pdf
- 2G8647_006.pdf
- 6 Specifications
- Location
- Equipment Specifications
- Operating Space Requirements
- Other Location Considerations
- Environmental Requirements
- Temperature
- Relative Humidity
- Altitude
- Floor Vibration
- Floor Levelness
- Environmental Effects
- Power Requirements
- Network Requirements
- Film
- Film Types
- Film Sizes
- Film Storage and Throughput
- 2G8647_gls.pdf
2010-11-04 2G8647 2-1
2
Using and Maintaining the
Imager
Operator Control of the Imager
During normal operation, the 6850 Laser Imager receives and
automatically prints images sent by modalities over a network. Very
little operator control is required. The main responsibilities of the
operator are:
• turning Imager power ON and OFF.
• loading film cartridges.
• taking recommended actions when preventive maintenance (PM) or a
filter maintenance request is indicated on the touch screen.
• monitoring and controlling some Imager functions using the touch
screen.
Turning Imager Power ON and OFF
There is a power switch and a power button on the 6850 Laser Imager.
The power switch should only be used the first time the Imager is
powered ON or when an immediate shutdown is required. For normal
operations, use the power button.
Power button
Power switch
Local panel