User's Manual
Table Of Contents
- 2G8647_001.pdf
- 2G8647_002.pdf
- 2 Using and Maintaining the Imager
- Operator Control of the Imager
- Turning Imager Power ON and OFF
- Power ON
- Normal Power OFF
- Emergency Power OFF
- Power Failures
- Power Save
- Using the Touch Screen
- Touch Screen Functions
- Touch Screen Help
- General Help
- Specific Screen Help
- Installation Road Map
- Physical Setup
- Configuration
- Imager Passcode
- Loading and Removing the Film Cartridges
- Drawers and Doors
- Opening Film Drawers and Main Door
- Opening the Film Registration Door
- Opening Air Intake Door
- Film Drawers and Main Door Manual Override Latch
- Filter Maintenance
- Cleaning the Electronics Filter
- Changing the PMM
- 2G8647_003.pdf
- 2G8647_004.pdf
- 4 Adding a Modality and Configuring Modality Image Quality
- Introduction
- Adding a Modality
- Configuring Modalities Automatically
- Configuring Modalities Manually
- Configuring Modalities that use PLUTs
- Configuring Modalities that use TFT Sets and Contrast Tables
- Fine Tuning the Image with TFTs Sets and Contrast Tables
- Performing a Contrast Test
- 2G8647_005.pdf
- 2G8647_006.pdf
- 6 Specifications
- Location
- Equipment Specifications
- Operating Space Requirements
- Other Location Considerations
- Environmental Requirements
- Temperature
- Relative Humidity
- Altitude
- Floor Vibration
- Floor Levelness
- Environmental Effects
- Power Requirements
- Network Requirements
- Film
- Film Types
- Film Sizes
- Film Storage and Throughput
- 2G8647_gls.pdf
Using and Maintaining the Imager
2010-11-04 2G8647 2-3
Power Failures In the event of a power loss, the 6850 Laser Imager shuts down. Films in
process will not be completed and will remain where they are until they
are removed (see “Correcting Film Jams With the Imager Powered OFF”
on page 3-2).
To restart the Imager after power is restored, turn OFF the power switch
on the Imager and then turn it ON. After warming up, the Imager
automatically reprints any films that were in process when power was
interrupted.
NOTE: If the Imager does not restart after pressing the power switch, press
the power button on the local panel (see “Turning Imager Power ON
and OFF” on page 2-1).
Power Save The Imager has a Power Save option, which lets you reduce the power
consumption of the Imager during periods of inactivity. To learn more
about the Power Save option, see the general help information on the
touch screen (see “General Help” on page 2-6).
Using the Touch Screen
Use the touch screen to monitor Imager operations and to control some
Imager functions.
Unlock icon Help icon
Film drawer icons