User's Manual
Table Of Contents
- 2G8647_001.pdf
- 2G8647_002.pdf
- 2 Using and Maintaining the Imager
- Operator Control of the Imager
- Turning Imager Power ON and OFF
- Power ON
- Normal Power OFF
- Emergency Power OFF
- Power Failures
- Power Save
- Using the Touch Screen
- Touch Screen Functions
- Touch Screen Help
- General Help
- Specific Screen Help
- Installation Road Map
- Physical Setup
- Configuration
- Imager Passcode
- Loading and Removing the Film Cartridges
- Drawers and Doors
- Opening Film Drawers and Main Door
- Opening the Film Registration Door
- Opening Air Intake Door
- Film Drawers and Main Door Manual Override Latch
- Filter Maintenance
- Cleaning the Electronics Filter
- Changing the PMM
- 2G8647_003.pdf
- 2G8647_004.pdf
- 4 Adding a Modality and Configuring Modality Image Quality
- Introduction
- Adding a Modality
- Configuring Modalities Automatically
- Configuring Modalities Manually
- Configuring Modalities that use PLUTs
- Configuring Modalities that use TFT Sets and Contrast Tables
- Fine Tuning the Image with TFTs Sets and Contrast Tables
- Performing a Contrast Test
- 2G8647_005.pdf
- 2G8647_006.pdf
- 6 Specifications
- Location
- Equipment Specifications
- Operating Space Requirements
- Other Location Considerations
- Environmental Requirements
- Temperature
- Relative Humidity
- Altitude
- Floor Vibration
- Floor Levelness
- Environmental Effects
- Power Requirements
- Network Requirements
- Film
- Film Types
- Film Sizes
- Film Storage and Throughput
- 2G8647_gls.pdf
2-6 2G8647 2010-11-04
Using and Maintaining the Imager
General Help The general Help provides basic information about the Laser Imager and
its functions.
1. On the Main Screen, touch the Help button.
2. Select a:
• Topic heading
• Specific topic
3. Touch View Topic.
Specific Screen Help This type of Help provides information and/or instructions concerning
the screen on which the Help button was touched.
Installation Road Map
The following sections provide a quick guide to the installation process.
There are two parts to the installation process: physical setup and
configuration.
Physical Setup This process includes:
• Uncrating the Imager (see the uncrating instructions affixed to the crate)
• Moving the Imager to its location (see Getting Started with the 6850
Laser Imager, 8H5320)
• Installing film trays (see Getting Started with the DRYVIEW 6850 Laser
Imager, 8H5320)
• Connecting to the network (see Getting Started with the DRYVIEW 6850
Laser Imager, 8H5320)
• Turning on power to the Imager (see Getting Started with the DRYVIEW
6850 Laser Imager, 8H5320)
Configuration Configuration is the process of setting parameter values in the Laser
Imager to customize it to produce quality prints from images sent from
the modalities at this site.
Configure the Imager using the touch screen. From the Main Screen,
touch Utilities>Configuration>Installation Assistant.
You can exit the Installation Assistant any time and return to it later.
The following list outlines the basic configuration process.
• Select your language
• Select a service phone number
• Set up the date and time
– Select your time zone
– Select the current date and date format