User's Manual
Table Of Contents
- 2G8647_001.pdf
- 2G8647_002.pdf
- 2 Using and Maintaining the Imager
- Operator Control of the Imager
- Turning Imager Power ON and OFF
- Power ON
- Normal Power OFF
- Emergency Power OFF
- Power Failures
- Power Save
- Using the Touch Screen
- Touch Screen Functions
- Touch Screen Help
- General Help
- Specific Screen Help
- Installation Road Map
- Physical Setup
- Configuration
- Imager Passcode
- Loading and Removing the Film Cartridges
- Drawers and Doors
- Opening Film Drawers and Main Door
- Opening the Film Registration Door
- Opening Air Intake Door
- Film Drawers and Main Door Manual Override Latch
- Filter Maintenance
- Cleaning the Electronics Filter
- Changing the PMM
- 2G8647_003.pdf
- 2G8647_004.pdf
- 4 Adding a Modality and Configuring Modality Image Quality
- Introduction
- Adding a Modality
- Configuring Modalities Automatically
- Configuring Modalities Manually
- Configuring Modalities that use PLUTs
- Configuring Modalities that use TFT Sets and Contrast Tables
- Fine Tuning the Image with TFTs Sets and Contrast Tables
- Performing a Contrast Test
- 2G8647_005.pdf
- 2G8647_006.pdf
- 6 Specifications
- Location
- Equipment Specifications
- Operating Space Requirements
- Other Location Considerations
- Environmental Requirements
- Temperature
- Relative Humidity
- Altitude
- Floor Vibration
- Floor Levelness
- Environmental Effects
- Power Requirements
- Network Requirements
- Film
- Film Types
- Film Sizes
- Film Storage and Throughput
- 2G8647_gls.pdf
Adding a Modality and Configuring Modality Image Quality
2010-11-04 2G8647 4-5
3. Select the best image and make note of the TFT Set/Contrast Table
for that image.
4. If you are satisfied with the best image, do the following.
a.
Exit the test screen.
b. On the Modality Configuration screen, select the Contrast Table and
TFT Set you want to use.
c. Touch Save.
5. If you determine that the best image is an improvement and you
want to continue fine tuning, do the following.
a.
Exit the test screen.
b. On the Modality Configuration screen, change the Contrast Table and
TFT Set you want to use.
c. Touch Contrast Test.
d. Run a Custom Contrast Test only (see “Performing a Contrast Test”
on page 4-6).
e. Touch OK.
f. Repeat step 5 until you determine the best image.
6. Backup the configuration. Touch:
• Close
• Close
• Backup
• Ye s
• OK