User Manual
Table Of Contents
- 1 Safety and Regulatory Information
- Document Conventions
- Intended Use and Indications for Use
- Safety and Related Information
- DRX-1 System Product Information
- Disposal Information
- Operating Environment
- 2 Hardware and Operation
- Overview
- CARESTREAM DRX-1 System
- Cautions
- Installing the Hardware
- CARESTREAM DRX-1 System Battery
- Labeling the Detector
- DRX-1 Detector LED
- Positioning the Detector in the Bucky
- Range of Operation
- Wireless Operation
- Tether Operation
- Cleaning the Hardware
- With Each Occurrence of Patient Contact
- System Maintenance
2-8 7H8166
Hardware and Operation
LED Pattern Meaning Action
1 Green Flash Detector is in Standby, no study is active;
Console may not be connected. Low
Power.
No action required. Detector is not being
used.
2 Green Flashes System is on, and Ready. No action required. LED indicates the
detector has been selected.
3 Green Flashes System is on and enabled, but not ready. Should not display in normal operation.
If this pattern is visible, call Service.
4 Green Flashes System is on and enabled, appears while
pressing the prep switch.
Do not report an error if this pattern is
not visible.
5 Green Flashes Power fault has occurred. Detector is
unusable.
Remove and re-insert the battery to clear
the problem. If the problem persists, call
Service.
1 Blue Flash Detector is currently connected to the
System Console.
No action required.
2 Blue Flashes Detector not currently connected to the
System Console.
If this pattern occurs while detector is in
use, call Service.
3 Blue Flashes Detector has rebooted and has not yet
connected to System Console.
If pattern occurs when the Detector
should be in use, call Service.
4 Blue Flashes Detector is performing firmware upload. Do not interact with the Detector.
5 Blue Flashes Detector is attempting to connect to the
Wireless Access Point.
No action required.
H224_0019AC
LED
Label