Installation Instructions

KODAK RVG 6500 System_User & Installation Guide (SM745)_Ed02 49
Quick Trouble Shooting for WiFi
To minimize WiFi network malfunctions, make sure that:
• The Wi-Fi access point, in use, is the one delivered by the manufacturer with the Kodak
RVG 6500 System and Kodak RVG 6500 IPS System (Netgear WGR614).
• The computer in use, has at least the requirements listed in KODAK RVG 6500
System_Regulatory User Guide (SM737)_Ed01B, Chapter 3.
• The installation and configuration of the network has been done following the steps given
in Chapter 5 of this document.
• The distance between different elements of the configuration is respected (See Chapter 5
of this document).
To correct the malfunction of your WiFi network, follow these steps:
1 Turn OFF the WiFi access point.
2 Turn OFF the RVG sensor control box.
3 Turn ON the WiFi access point and wait a minute and check that:
• is on.
• is on. Then goes off when the system is ready and running.
• is on.
4 Press the remote control button of the RVG control box to turn ON the device. The blinking blue
light indicates the sensor attempt to connect to the WiFi access point. Wait for the blinking blue
light (A) to become solid blue. (B) The sensor is connected to the WiFi access point.
5 If the sensor cannot connect to the WiFi access point, see Tables 2 and 3.
6 If the WiFi access point functions correctly but cannot connect to your computer, see your
computer’s Troubleshooting section.
A
B