Operation Manual

Monogramming and embroidering with embroidery hoop
Attach the darning plate
Preparation for Monogramming
and Embroidering*
- Remove the presser foot and
the presser foot holder.
- Lower presser foot lever before
starting to sew.
- Adjust the stitch width according
to the size of lettering or design.
- Draw the desired lettering or
design on the right side of the
fabric.
- Stretch the fabric between
embroidery hoop as firmly as
possible.
- Place the fabric under the
needle. Make sure the presser
foot bar is down in its lowest
position.
- Turn the balance wheel towards
you to bring up the lower thread
through the fabric. Sew a few
securing stitches at the starting
point.
- Hold the hoop with thumb and
forefingers of both hands.
- Coordinate sewing speed and
movement of hoop.
*Embroidery hoop not included
with machine.
Needle position Stitch width Stitch length
Middle Any 0
19