Operation Manual

Changing the bulb
Disconnect the machine from
the power supply by removing
the plug from the main socket!
- Loosen screw as illustrated.
- Remove the face cover.
- Unscrew the bulb and fit new
one.
- Replace the cover and
tighten screw.
Should there be any problem.
Ask your local dealer for
advice.
Needles must be in perfect
condition. Change the needle
regularly, especially if it is
showing signs of wear and
causing problems.
Insert the needle following the
illustrated instructions.
A. Loosen the needle clamp
screw and tighten again
after inserting the new
needle.
B. The flat side of the shaft
should be towards the back.
C/D. Insert the needle as far up
as it will go.
Turn power switch to off ("O").
Attention:
A
B
C
D
5
Inserting the needle