Operation Manual

Mark the design on the fabric. Insert the cord in

the center groove of the cording foot from the

right side opening. Pull the cord about 5cm (2

inches) behind the foot.

The grooves under the foot will hold the length

of the cord in place while the stitches are being

form over the cord.

Select the stitch and adjust the stitch width so

that the stitches are just covering the cord. Lower

the foot and sew slowly, guiding the cord over

the design.

Single cording

Sew over one strand of cording to create a pretty swirled design on a jacket or vest or sew over three

strands of cording for border trims. Pearl cotton, knitting yarn, embroidery floss, lace thread, fine wool or

lily yarn can be used for cording.

Triple cording

Push the sewing thread to the left and insert three

cords into the grooves of the foot and pull about

5cm (2 inches) of the cords behind the foot.

Select the desired pattern and adjust the stitch

width so that the stitches are just covering the

cords. Lower the foot and sew slowly guiding the

cords.

Cording

* The foot accessory is optional. It is not included with this machine.Cording