Operation Manual

Warning Functions
Lowering the buttonhole lever
When you select any buttonhole pattern or darning
pattern, LCD screen will show the figure " ". It is to
remind you to lower the buttonhole lever.
Bobbin winding
When the bobbin winder spindle is activated for
bobbin winding (in the rightmost position) this
appears on the LCD screen as a reminder.
figure
Instruction message display
Patterns
Patterns
Attention: During the sewing, if the thread get jammed inside the hook stopping the needle from moving
and you continue pressing the foot control, the security switch will stop the machine completely. In order
to restart the sewing machine, you will have to turn the on/off switch to the OFF position and then ON
again.
- When operating correctly: 1 beep
- When the memory is full 30 units of pattern: 2-short beeps
- When operating incorrectly: 3-short beeps
- When the sewing machine is in trouble and can't sew: 3-short beeps
It means that the thread is twisted or jammed and the hand wheel axle can't move. Please look t hrough
the "Trouble shooting guide" on page 62/63 to find the solution. After the problem has been solved, the
machine will continue to sew.
Warning beeping sound
Please Note: If the problem is still not solved, please contact your local dealer.
Return bobbin winder spindle to left
If you press any button on the machine when the
bobbin is full or the bobbin winder spindle is in
the right position, then the machine will beep 3
times as a warning.
Return the bobbin winder spindle to the left
position.
59