Operation Manual

ON
OFF
4
2. Setting up machine
4. Cloth Press
The cloth presser is to prevent
cloth/fabric/materials
from flapping during the felting process.
Place the cloth/fabric/materials on the
needle plate and under the cloth presser.
Loosen the presser height adjusting
screw to adjust the height of the cloth
presser until you get the correct height for
your cloth/fabric/material, then tighten the
presser height adjusting screw.
The cloth/fabric/materials should move
freely under the cloth presser without any
restrictions.
3. Felting speed
The felting speed can be adjusted by
increasing or decreasing the pressure on the
foot controller.
2. Polarized Plug
This appliance has a polarized plug(one
blade wider than the other). To reduce the
risk of electric shock, this plug is intended
to fit in a polarized outlet only one way. If
the plug does not fit fully in the outlet,
reverse the plug. If is still does not fit,
contact a qualified electrician to install the
proper outlet.
Do not modify the plug in any way.
Use only foot controller provided with this
machine.
(Type 4C-316B for U.S.A. & CANADA only)
1. Attaching the foot control
Plug the power cord of foot controller into
machine socket, then into a wall outlet.
Always make sure the power is off and
remove the plug from the wall outlet when
the machine is not in use, or when making
any adjustments such as changing needles
or light bulb.
WARNING: