Technical data

Vario II series
Label creation
06/10
Operating manual
37
7.2 Vektor fonts
Press key
and the display indicates the following text mask:
Press key
E to access the next field.
Selected values are only accepted if the entry was confirmed with key
.
Press key
and to increase and/or decrease the number of mask
record (number of lines).
Y - Distance from top in mm
It is measured from the upper label margin to the lower left point of the
corresponding line.
EY - Extension in direction Y
Height of font in mm
T - Selection of font type
04 - Vector fonts proportional
05 - Vector fonts autoscale
06 - Vector fonts proportional inverse
07 - Vector fonts autoscale inverse
Proportional:
In case of using proportional, then font height and width are displayed
in mm. These values refer to the first letter, i.e. the values of other
characters were modified correspondingly.
Autoscale:
In case of using autoscale, then the font height and width are
displayed in mm. The font height refers to all capital letters. The height
of small letters and descenders is modified proportionally. The
complete field width is entered as width and the entered text is
automatically fit to this field, i.e. the width of the characters changes.
S - Spaces between characters
Proportional:
min.: 1 x 0,083 mm - max.: 99 x 0,083 mm
Autoscale: no function, because the width of the characters is
fit to the field width
X - Distance from right side in mm
It is measured from the right label margin to the lower left point of the
corresponding line.
EX - Extension in direction X
Proportional:
character width in mm (factor 1 - 99, should be the
same as EY)
Autoscale:
field width in mm (up to 99 mm)
Mask entry