Technical data

Vario II series
Label creation
06/10
Operating manual
45
Press key
and the display indicates the following text mask:
Press key
E to access the next field.
Selected values are only accepted if the entry was confirmed with key
.
Press key
and to increase and/or decrease the number of mask
record (number of lines).
Y - Distance from top in mm
It is measured from upper label margin to lower left point of the
corresponding line.
H - Height of symbol
Zoom factor, the entry is possible in 1/10 mm steps between 01 and
99
T - Type of code
52 = DataMatrix
Z - Format ID
The format ID describes the format of data which is to code.
Entry
interface
Format ID Data to code
0
11
numeric, 2000 characters
1
1
numeric, 500 characters
2
2
alphabetical, 500 characters
3
3
alphabetical + pointers, 500 characters
4
4
alphanumeric, 500 characters
5
5
7 Bit, 500 characters
6
6
8 Bit, 500 characters
7
7
pre-programmed, 500 characters
8
12
alphabetical, 2000 characters
9
14
alphanumeric, 2000 characters
The format IDs which are displayed in grey are not supported from the
printer.
In case ECC 200 is set then it is not possible to evaluate the format
ID. In this case at least 3116 numeric res. 2335 alphanumeric signs
are possible.
X - Distance from right side in mm
It is measured from right label margin to upper left point of the
corresponding line.
Mask entry DataMatrix