Microscope & Magnifier User Manual

05/2008 25
Press the New button to open a new FCS diagram into an image container. If a
measurement is triggered, all data are displayed in that window if highlighted.
Press the Start button to trigger a measurement. All defined positions will be
approached consecutively.
Press the Single button to trigger one measurement at the highlighted or first
defined position.
Press the Stop button to end a measurement. All data accumulated so far will be
available and can be stored.
Press the xyz-Scan button to display the current coordinates. You can define
boundaries where a scan is performed with simultaneous acquisition of the count
rate. This allows you, for example, to identify labeled molecules accumulated in the
membrane.
Press XY Stage if positioning should be accomplished by the motorized stage.
Press Scanner if the positioning should be accomplished by the scanning mirrors
After measurement completion, the data is displayed in the FCS Correlation diagram within an Image
Container (see
Fig. 31)