Installation & Assembly

ASSEMBLY INSTRUCTIONS FOR TRANSPORT CART
P.O. Box 53006
Oklahoma City, Oklahoma 73152-3006
[phone] • FAX [phone]
1-800-654-8210
www.carlislefsp.com
European Distribution Center:
Edisonstraat 84, P.O. Box 110
6900 AC Zevenaar, The Netherlands
Tel [phone] • Telex 45642
FAX [phone]
#104803330
Tools Requirements: Rubber Mallet; cushioned assembly surface
With just a rubber mallet and 15 minutes, your
new Transport Cart assembles quickly and easily.
1.) Using either Side (2 long
curved Panels) determine
top orientation as shown in
illustration (1)
1
2a
2b
Top
CC2036
2.) Locate the Middle Shelf (shelf with 4 slots – 2 on either
end). Align slots on shelf with inside ribs on back of Side
Panel above the middle cross brace as shown (2a). Pressing
the Middle Shelf into the back of the Side Panel, hammer the
Middle Shelf into place. When complete, the 2 large tabs on
the end of the Middle Shelf should extend through the 2
corresponding slots on the Side Panel as shown (2b).
3.) Stand up Shelf and Panel assembly. Align the 2 remaining exposed
tabs on the end of the Shelf with the two slots on the opposite Side
Panel. While pressing the Shelf into the Panel, hammer Shelf into place
as in step two
(3). Please note that the Middle Shelf has a retaining lip
along its back edge. Make sure to align the corresponding lips on the
other two shelves with this one as you attach them in Steps 4 and 6.
3
Posts
Locking Tabs