Specification

Table Of Contents

Thomas and Betts Corporation

Product Guide Specification

COMMERCIAL GRADE NON-METALLIC

LIQUIDTTIGHT FITTINGS AND CONDUIT

26 05 33.27-1

REVISION 0

Specifier Notes: This product guide specification is written according to the Construction Specifications Institute

(CSI) 3-Part Format, including MasterFormat, SectionFormat, and PageFormat, as described in The Project

Resource Manual—CSI Manual of Practice, Fifth Edition.

This section must be carefully reviewed and edited by the Architect or Engineer to meet the requirements of the

project and local building code. Coordinate this section with other specification sections and the Drawings. Delete

all “Specifier Notes” after editing this section.

Section numbers are from MasterFormat 2010 Update.

SECTION 26 05 33.27

COMMERCIAL GRADE NON-METALLIC LIQUIDTIGHT FITTINGS AND CONDUIT

Specifier Notes: Delete any information below in Parts 1, 2 or 3 which is not required or relevant for the project.

PART 1 – GENERAL

1.01 SUMMARY

A. Section includes commercial grade non-metallic fittings, conduit and tubing for liquidtight applications.

B. Related Sections:

1. Section 26 05 33.21 Non-metallic Junction Boxes

2. Section 26 05 33.33 Industrial Grade Non-metallic Liquidtight Fittings and Conduit

1.02 REFERENCES

A. Underwriters Laboratories, Inc (UL):

1. UL 514B Conduit, Tubing, and Cable Fittings

2. UL 1660 Liquid-Tight Flexible Nonmetallic Conduit (LFNC)

3. UL 1696 Nonmetallic Mechanical Protection Tubing (NMPT)

B. Canadian Standard Association (CSA):

1. C22.2 No. 18 Outlet Boxes, Conduit Boxes, Fittings and Associated Hardware

2. CSA C22.1 Canadian Electrical Code Part I

C. National Fire Protection Association (NFPA)

1. NFPA 70 National Electrical Code (NEC)

1.03 SUBMITTALS

A. Comply with Section 01 33 00 – Submittal Procedures.

B. Product Data:

1. Submit manufacturer’s descriptive literature and product specifications for each product.

2. Manufacturer’s product drawings.

C. Manufacturer’s installation instructions.

1.04 QUALITY ASSURANCE

A. Manufacturer Qualifications: Products shall be free of defects in material and workmanship.

PAGE 1
Thomas and Betts Corporation Product Guide Specification Specifier Notes: This product guide specification is written according to the Construction Specifications Institute (CSI) 3-Part Format, including MasterFormat, SectionFormat, and PageFormat, as described in The Project Resource Manual—CSI Manual of Practice, Fifth Edition. This section must be carefully reviewed and edited by the Architect or Engineer to meet the requirements of the project and local building code.
PAGE 2
Thomas and Betts Corporation Product Guide Specification B. 1.05 Furnished products are listed, recognized and/or classified by third party agencies as being suitable for the intended purpose. WARRANTY A. Product is warranted free of defects in material and workmanship. B. Product is warranted to perform the intended function within design limits. PART 2 – PRODUCTS 2.01 2.02 GENERAL A. The following construction styles shall be available: 1.