Specification

ManualsBrandsCarlon ManualsKitchen1-Gang 9-3/4 cu. in. Surface Mount Box (Case of 100)

Table Of Contents

A. Comply with Section 01 33 00 – Submittal Procedures.

Thomas and Betts Corporation

Product Guide Specification

NON-METALLIC OUTLET BOXES

26 05 33.17-2

REVISION 0

1.05 WARRANTY

A. Product is warranted free of defects in material and workmanship.

B. Product is warranted to perform the intended function within design limits.

PART 2 – PRODUCTS

2.01 GENERAL

A. PVC, Phenolic and Polycarbonate non-metallic boxes shall be listed and comply with NEMA OS-2.

B. PVC non-metallic low voltage brackets shall be listed.

2.02 MANUFACTURERS

A. Acceptable Manufacturers:

Thomas & Betts Corporation

8155 T&B Blvd

Memphis, TN 38125

800-816-7809, 901-252-5000

www.tnb.com

Products:

1. Carlon® Blue™ and SuperBlue™ PVC Boxes

2. Carlon® Phenolic Boxes

3. Carlon® Polcarbonate Boxes

4. Carlon® Low Voltage Brackets

2.03 DESIGN AND PERFORMANCE REQUIREMENTS

A. PVC Non-metallic Outlet Boxes;

1. Non-metallic outlet boxes shall be molded from PVC.

2. PVC non-metallic outlet boxes shall not rust.

3. PVC non-metallic outlet boxes shall be provided with knockouts or cable clamps to facilitate

wiring.

4. PVC non-metallic outlet boxes shall be listed for use with masonry walls.

5. PVC non-metallic outlet boxes shall be UL Classified for a 2 hour fire rating for walls and

ceilings.

6. PVC non-metallic outlet boxes shall be listed for use with 90 degree C conductors.

7. PVC non-metallic ceiling boxes shall be UL listed for fixture or fan support.

B. Phenolic Non-metallic Outlet Boxes:

1. Non-metallic outlet boxes shall be molded from Phenolic

2. Phenolic non-metallic outlet boxes shall not rust.

3. Phenolic non-metallic outlet boxes shall be provided with knockouts or cable clamps to

facilitate wiring.

4. Phenolic non-metallic outlet boxes shall be listed for use with masonry walls.

5. Phenolic non-metallic outlet boxes shall be UL Classified for a 2 hour fire rating for walls and

ceilings. Phenolic non-metallic outlet boxes may be installed in same wall stud cavity of a

shared two-hour wall per it’s UL classification. Phenolic non-metallic outlet boxes may

face opposite directions with only a 3” horizontal separation per it’s UL Classification.

6. Phenolic non-metallic outlet boxes shall be listed for use with 90 degree C conductors.

7. Phenolic non-metallic ceiling boxes shall be UL listed for fixture and/or fan support.