Specification

Table Of Contents

Thomas and Betts Corporation

Product Guide Specification

RIGID NON-METALLIC CONDUIT ELBOWS

26 05 33.50-1

REVISION 0

Specifier Notes: This product guide specification is written according to the Construction Specifications Institute

(CSI) 3-Part Format, including MasterFormat, SectionFormat, and PageFormat, as described in The Project

Resource Manual—CSI Manual of Practice, Fifth Edition.

This section must be carefully reviewed and edited by the Architect or Engineer to meet the requirements of the

project and local building code. Coordinate this section with other specification sections and the Drawings. Delete

all “Specifier Notes” after editing this section.

Section numbers are from MasterFormat 2010 Update.

SECTION 26 05 33.50

RIGID NON-METALLIC CONDUIT ELBOWS

Specifier Notes: Delete any information below in Parts 1, 2 or 3 which is not required or relevant for the project.

PART 1 – GENERAL

1.01 SUMMARY

A. This section includes rigid PVC schedule 40 and 80 elbows, belled and plain ends for use with non-

metallic solvent weld fittings.

1.02 REFERENCES

A. Underwriters Laboratories, Inc. (UL):

1. UL 651 Schedule 40 and 80 Rigid PVC Conduit and Fittings

B. National Fire Protection Association (NFPA):

1. NFPA 70 National Electrical Code (NEC)

C. Intertek Testing Services (ETL):

1. ETL is an OSHA-recognized National Recognized Testing Laboratory for product compliance

in accordance to the NEC..

1.03 SUBMITTALS

A. Comply with Section 01 33 00 – Submittal Procedures.

B. Product Data:

1. Submit manufacturer’s descriptive literature and product specifications for each product.

2. Manufacturer’s product drawings.

1.04 QUALITY ASSURANCE

A. Manufacturer Qualifications: Products shall be free of defects in material and workmanship.

B. Furnished products shall be listed or classified by a third party agency as suitable for the intended

purpose.

1.05 WARRANTY

A. Product is warranted free of defects in material and workmanship.

PAGE 1
Thomas and Betts Corporation Product Guide Specification Specifier Notes: This product guide specification is written according to the Construction Specifications Institute (CSI) 3-Part Format, including MasterFormat, SectionFormat, and PageFormat, as described in The Project Resource Manual—CSI Manual of Practice, Fifth Edition. This section must be carefully reviewed and edited by the Architect or Engineer to meet the requirements of the project and local building code.
PAGE 2
Thomas and Betts Corporation Product Guide Specification B. Product is warranted to perform the intended function within design limits. PART 2 – PRODUCTS 2.01 2.02 GENERAL A. Rigid PVC Schedule 40 and 80 Elbows shall be UL or ETL Listed for underground, encased or exposed applications in accordance with the National Electrical Code Article 352. B. Rigid PVC schedule 40 and 80 elbows shall be available in trade sizes from1/2” to 6”. C.