Operation Manual

Carlson Wireless USA revision 1.05 Page 16
Consumer and US Regulatory Information
Connection to the telephone network
1. The Federal Communications Commission (FCC) has established rules
which permits this device to be directly connected to the telephone network.
2. If this device is malfunctioning, it may also be causing harm to the tele-
phone network; this device should be disconnected until the source of the
problem can be determined and until repair has been made. If this is not
done, the telephone company may temporarily disconnect service.
3. The telephone company may make changes in its technical operations
and procedures; if such changes affect the compatibility or use of this device,
the telephone company is required to give adequate notice of the changes.
4. If the telephone company requests information on what equipment is con-
nected to their lines, inform them of:
(a) The telephone number that the unit is connected to
(b) The ringer equivalence number
(c) The USOC jack required
(d) The FCC Registration number
Item (b) and (c) are indicated on the label.
5. In the event of equipment malfunction, all repairs should be performed by
our company or an authorized agent. It is the responsibility of users requiring
services to report the need for service to our company or to one of our author-
ized agents.
Service can be obtained at: Carlson Wireless Telephone Inc.,
1150 Evergreen Road
P.O. Box 2400,
Redway, CA 95560 USA,
Tel: [phone]
FCC Reg No., Part 68 BMD USA – 27773-PT-E
Notification to the telephone company
The equipment complies with Part 68 of the FCC rules. You will find the label
located on the device. This label contains the FCC Registration Number and
the Ringer Equivalence Number ((REN) for this equipment. You must, upon
request, provide this information to your telephone company.
Carlson Wireless USA revision 1.05 Page 5
The i-WLL breakthrough offers many advantages not found in the market to-
day:
• Never needs tuning because i-WLL is a 100% digital, self-configuring,
eight channel system. This simplifies installation and greatly reduces the
need for maintenance and service over time.
• Complete privacy is assured by the fully encrypted, spread-spectrum
modulation scheme.
• Highly efficient spectrum use from a unique combination of FDMA and
CDMA.
• Seamless integration with the global telephone network assured by i-
WLL’s worldwide ISDN system architecture with full 144 kbps bandwidth.
• No individual license needed for operation - i-WLL uses the globally li-
cense-free 2.4 GHz ISM frequency band.
• Flexible voltage – low power usage - just 3 to 6 Watts at any DC voltage
between 12 and 55V.
• Small, lightweight, self-contained units make i-WLL easy to install - no
special expertise needed. i-WLL FXO (central office) and FXS
(subscriber) units - which include all electronics, antenna and RF ca-
bling - are housed in a weatherproof enclosure 4.5" in diameter by 30"
long (11.5 x 76.2 cm) .