Operator's Manual

PRELIMINARY RELEASE
*** This is a confidential document. Do not distribute. ***
Click on the arrow to the left of any Basestation. This will expand the “cell” list, showing
associated CPEs.
Clicking the “Id” or “Name” hyperlink of any station will give you a popup “Station Properties”
window. See Section 4.7 of this manual to learn more about Station Properties.
Figure 27: Expanded "Cell" List
4.5. Stations
Click on the “Stations” tab at the top of the OMC window.
This is a list of radios assigned to your
account. The OMC will only display
radios assigned to your account. If an
expected radio does not appear in this
list, you must make a request to Carlson
Support for a database update.
Each radi
o will have a customized name
and description. Unless requested
otherwise, Carlson will use a default
naming convention. Basestation names
begin with “CSB”, followed by the serial
number with one leading zero removed
(i.e., “CSB00123”). CPE names begin
with “CST”, using the same serial
number syntax (i.e., "CST00123").
The “Rbt” column shows if the
Basestation is currently in a “soft-reboot”
state, indicated by a checkmark. The radio is not accessible while in this state; access will
resume upon successful completion of the boot sequence.
Figure 28: Stations Display
Note: the Basestation boot process can take up to five (5) minutes or more.
The “Last Reported” column displays the amount of time elapsed since your Basestation last
reported state to the OMC. Active Basestations always report in less than one minute, indicated
in green.
4.6. Cell Control
Click the “Cell Control” tab at the top of the OMC window.
Page | 24