Operator's Manual

PRELIMINARY RELEASE
*** This is a confidential document. Do not distribute. ***
Additional Information on TV Band Interference Protection
This equipment has been tested and found to comply with the rules for TV band devices,
pursuant to Part 15 of the FCC Rules. These rules are designed to provide reasonable
protection against harmful interference. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
4. Consult the manufacturer, dealer or an experienced radio/ TV technician for help.
FCC Registration Requirements
Per FCC regulations; you must register your RuralConnect® system with a certified spectrum
database (such as Spectrum Bridge) prior to performing any bench tests and/or completing the
final installation. You will need a Special Temporary Authority (STA) if you are using uncertified
experimental hardware or software.
Compliance and US Regulatory Information
FCC Identifier OPA-RC2
FCC Part 15H 470-608 MHz (TV channels 14-36)
FCC Part 15H 614-698 MHz (TV channels 38-51)
Emission designators
6 MHz channels 6M00F1D
Declaration of Conformity
Manufacturer’s Name: Carlson Wireless Technologies Inc.
Manufacturer’s Address: 2700 Foster Ave, Arcata, CA 95521 USA
Declares that the product:
Product Name: RuralConnect®
Conforms to the following standard(s) or other normative document(s):
EMC:
FCC Part 15.247 subpart H
Page | 4