Operator`s manual

During operation, working hours can always be displayed by switching for a BRIEF
INTERVAL key (+) or (-). The display shows now the ref. indicator “b” on page 7
and working hours are displayed for 3 seconds. During this interval the EVS solenoid
valve is energized or de-energized by the monitor (according to what programmed in
“type” parameter) only if the “auto-feed” function has been enabled (see chapter 5.3),
whereas the EVR solenoid valve is never energized.
5. Range of parameters displayed
Description Range
Engine RPMe 0 ÷ 9990 steps of 10 RPMs
Working
hours
0.0 ÷ 999.9 hours, steps of 0.1 hour ( 6 minutes ); once 999.9 are
reached, then steps of 1 hour until 9999 hours.
Working hours increase only if RPMs > 500.
6. Setting
The device has two setting phases: “user” setting and "manufacturer" setting. Both
programming phases can be carried out with the engine operating (RPMs > 500). The
operator shall complete the procedure for each phase by confirming all parameters at
a time to allow all modified parameters are stored. Otherwise, if the operator is within
one programming phase and no key is selected for an interval of 7 seconds, the
monitor quits the phase WITHOUT storing any executed changes.
The “user” phase permits programming of the following parameters:
• Minimum value for RPMs
• Maximum value for RPMs
• Machine type selection (with or without reverse)
•
Reverse time (not used if the reverse valve is not present).
The “manufacturer” setting allows programming of the following parameter:
•
Pulses/revolution for engine RPMs counting (Set By Factory)
NOTES: the parameter value is kept displayed during each programming phase; the
parameter name is displayed only while going from one parameter to the next one or
when keys + (plus) and (-) minus are simultaneously pressed.
For safety purposes, the EVS solenoid valve is energized or de-energized (according
to what programmed in “type” parameter) by the monitor each time a programming
phase is entered only if the “auto-feed” function has been enabled (see par. 5.3),
whereas the EVR solenoid valve is never energized.