Operator`s manual

9” CHIPPER MACHINE CONTROLS
23
FRONT JACK STAND
• Use the front jack stand anytime the
chipper is removed from the tow vehicle.
Do not depend on this jack stand to
support the machine for stand-alone
operation by itself. The tires must be
blocked using wheel chocks and the rear
jack stand must be used. The front jack
stand can be attached to the tongue on
either side of the machine. The jack
stand can then be rotated up and stored
on either side of the machine during
transport.
REAR JACK STAND
• When the chipper is uncoupled from the
tow vehicle at the job site, use the rear
jack stand for support. The rear jack
stand should be used along with the front
jack stand, and wheel chocks when using
the chipper in stand-alone operation.
FEED WHEEL CLEAN OUT DOOR
• There is a drop-down door to clean
excess debris out from under the bottom
feed wheel. This will help to keep the
chipper from getting clogged or stopped
up. Use the handle on the clean out
door, located behind the infeed chute
under the machine, and drop the door
down to remove debris, then close and
secure the door. Should be cleaned
frequently to prevent damage to clean
out door and to prevent clogging the
chipper. DO NOT open the clean out
door until the chipper has been shut
down and all parts have come to a
complete stop, danger of flying debris
could cause injury.
REAR JACK STAND
STAND ALONE OPERATION
REAR JACK STAND FRONT JACK STAND
WHEEL CHOCKS
FRONT JACK STAND