Specifications

3500D SERVICING CUTTER WHEEL
37
SAFETY
• NEVER SERVICE A MACHINE WITH THE ENGINE RUNNING, SEVERE
PERSONAL INJURY COULD OCCUR. TURN ENGINE OFF THEN REMOVE
IGNITION KEY AND DISCONNECT POSITIVE BATTERY CABLE TO AVOID
STARTING MACHINE ACCIDENTALLY.
• CUTTER WHEEL MUST BE DISENGAGED BEFORE TURNING ENGINE
ON/OFF AND BEFORE SERVICING A MACHINE. OTHERWISE SEVERE
PERSONAL INJURY COULD OCCUR AS WELL AS MACHINE DAMAGE.
• ALL MACHINE PARTS MUST COME TO A COMPLETE STOP AND HAVE
TIME TO COOL COMPLETELY BEFORE SERVICING A MACHINE OR
SEVERE INJURY COULD OCCUR, POSSIBLY SERIOUS BURNS AND/OR
DISMEMBERMENT.
• DO NOT OPERATE A MACHINE WITHOUT A COMPLETE SET OF TEETH
PROPERLY INSTALLED. EXCESSIVE MACHINE VIBRATION WILL OCCUR
CAUSING PREMATURE BEARING FAILURE AND OTHER EQUIPMENT
DAMAGE.
• PLACE THE CUTTER WHEEL ON THE GROUND WHEN PERFORMING
SERVICE ON A MACHINE.
• There are thirty-two (32) teeth to a
complete set on the model 3500D. Two
(2) straight teeth, fifteen (15) left 45°
teeth and fifteen (15) right 45° teeth.
• A locking pin is provided to hold cutter
wheel in position during tooth removal
and re-installation.
• Locking pin will only lock on outer
teeth. NEVER PLACE HAND ON
CUTTER WHEEL TO HOLD IN
PLACE WHILE CHANGING
TEETH. BE SURE TO REMOVE
PIN BEFORE OPERATING.
• A Tooth Setting Gauge (P/N - 0450111)
is provided with each machine for proper
tooth installation. Line all teeth up with
the inside edge of the groove in the
gauge. Set ALL teeth to this edge with
gauge against pocket, not against cutter
wheel.