Specifications

7500 DAILY CHECKLIST
9
• Make sure safety pins and safety chock
are in position before towing. Always
crisscross safety chains when towing.
• Check engine oil at dipstick. Add to full
mark, if required. Engine must be level
(see Machine Maintenance section).
• Check hydraulic oil level. A sight glass
is located on the hydraulic tank. Add oil
if required.
• Inspect dry air filters. REPLACE, if
necessary, WITH FACTORY AIR
FILTER ONLY. Do not blow out or tap
on ground. Replace inner safety filter
when dirty or when the outer air filter
has been changed 3 times. Do not blow
out the inner safety filter or tap on
ground. (See Engine Assembly section
for part numbers.)
• Check condition of tires. Inflate to
proper pressure.
• Check wheel lug nuts.
• Inspect towing hitch, safety chains and
towing lights.
• Check condition and tightness of engine
belts. (See Servicing Belts section)
New belts will stretch and become loose
as machine runs. Check belt tension
often when belts are new.
• Check for any loose, broken, cracked, or
missing cutter teeth and pockets.
Tighten or replace any loose or damaged
teeth or pockets before running stump
cutter.
• Inspect bolts, hydraulic fittings, wiring
harnesses, and hoses for looseness, wear,
or leakage. Replace if necessary.
• Machines are equipped with purgable
bearings on the cutter wheel shaft and
the jackshaft. Purge with new grease
EVERYDAY.
PURGE BEARINGS WITH GREASE DAILY
PINS