Specifications

7500 MACHINE CONTROLS
13
SAFETY
• NEVER SERVICE A MACHINE WITH THE ENGINE RUNNING, SEVERE
PERSONAL INJURY COULD OCCUR. TURN ENGINE OFF THEN REMOVE
IGNITION KEY AND DISCONNECT POSITIVE BATTERY CABLE TO AVOID
STARTING MACHINE ACCIDENTALLY.
• CUTTER WHEEL MUST BE DISENGAGED BEFORE TURNING ENGINE
ON/OFF AND BEFORE SERVICING A MACHINE. OTHERWISE SEVERE
PERSONAL INJURY COULD OCCUR AS WELL AS MACHINE DAMAGE.
• ALL MACHINE PARTS MUST COME TO A COMPLETE STOP AND HAVE
TIME TO COOL COMPLETELY BEFORE SERVICING A MACHINE OR
SEVERE INJURY COULD OCCUR, POSSIBLY SERIOUS BURNS AND/OR
DISMEMBERMENT.
• PLACE THE CUTTER WHEEL ON THE GROUND WHEN PERFORMING
SERVICE ON A MACHINE.
OPTIONAL RADIO CONTROL
CONVERTING FROM WIRED TO
RADIO TRANSMITTER
• To change from a wired to a radio
(wireless) transmitter, remove the cover
on the control box. There are 3 bolts on
each side.
• Turn cover over and drill holes in the
control box wall for attaching the radio
control receiver; make sure the hole
locations match the bolt locations on the
radio receiver. Attach the radio receiver
to the control box and replace the cover.
• Use the wiring and connector diagrams,
in the radio control manual included at
the back of this manual, to wire directly
to the appropriate contacts of the
machine electronics. Contact your
Carlton dealer if you need assistance not
the radio control manufacturer.
• The radio transmitter and receiver will
be programmed at the factory when
purchased as a set.
THE RADIO CONTROL
RECEIVER, SHOWN AT
THE RIGHT, MUST BE
INSTALLED IN THE
CONTROL BOX
REMOVE THE CONTROL BOX
COVER BOLTS (BOTH SIDES)
AND REMOVE COVER
DRILL HOLES IN THE RIGHT SIDE OF THE COVER
(SHOWN ABOVE) AND MOUNT THE RADIO CONTROL
RECEIVER INSIDE.
DRILL HOLES IN THIS SIDE OF THE
COVER TO MOUNT THE RECEIVER