Specifications

7500 MACHINE CONTROLS
15
PROGRAMMING – WIRELESS
• If there is a problem with the receiver or
the transmitter and either has to be
replaced, you will need to program the
new unit to communicate with the
existing unit. Or if you have more than
one transmitter for this machine, it will
need to be programmed to communicate
with the existing receiver.
• To program the transmitter and receiver,
you have to download the transmitter’s
unique code into the receiver. There are
complete instructions along with colored
illustrations in the radio control manual
included in the back of this manual.
• To access the receiver, remove the cover
from the machine control box.
• Remove the radio receiver panel by
unlatching the plastic tabs on either side
of the receiver; see the radio control
manual included in this manual at the
back. The receiver panel will now slide
out of the cap.
• Follow the instructions in the radio
control manual to download the ID
Code. There are specific instructions
that need to be followed and
corresponding illustrations. The radio
control manual is included in the back of
this manual.
• Push the receiver panel back up into the
cap until the tabs snap back into place.
• Always replace the machine cover when
maintenance or troubleshooting is
complete. DO NOT RUN MACHINE
WITHOUT ALL GUARDS & COVERS
IN PLACE AND SECURED.
REMOVE
COVER
RELEASE THE RADIO
RECEIVER CAP BY
UNLATCHING THE
TABS ON EACH SIDE