Specifications

7500 MACHINE OPERATION
20
• Lower spinning cutter wheel to stump and make
a few light passes at stump to get a feel for the
cutting action.
• Gradually increase cutting action and work
away at stump by swinging cutter wheel left-to-
right-to-left through stump in a sideways
motion. Smooth, effortless cutting lengthens
machine life, minimizes downtime and is more
profitable in the long run.
• Continue cutting stump by adjusting cutting
wheel progressively lower until stump is cut
well below ground level.
• Swing cutter wheel clear of stump and extend
tongue to position machine closer to stump for
next series of passes and continue cutting.
• Continue in this manner until stump has been
removed.
• Larger stumps may require repositioning
machine to work at best advantages.
• Raise cutter wheel clear of stump and return to
center position.
• Withdraw tongue extension.
• Reduce engine speed to idle and disengage drive
belts. DO NOT DISENGAGE DRIVE
BELTS AT A HIGH ENGINE SPEED.
Damage to belts and machine will occur.
• DO NOT TURN OFF MOTOR. Engine must
be allowed to cool slowly at idle for 3-5 minutes
to avoid damage.
• At low engine RPM cutter wheel swing speed
control needs to be closed for cutter head to
swing. Turn clockwise to close.
• Turn off motor.
• Allow cutter wheel to come to a full stop before
inspecting work area.