Specifications

7500 MACHINE MAINTENANCE
25
• Grease cutter wheel shaft bearings daily.
These bearings should be purged using
grease EVERYDAY. Purge until clean
grease is seen. Use Texaco® Starplex II
grease. Wipe off excess grease. Excess
grease will attract dirt. Always clean tip
of grease gun fitting and grease fitting on
machine before attaching hose to prevent
dirt from being forced into machine
parts.
• Grease the bearing supported stub shaft
every 1000 hours of operation using
Texaco
® Starplex II grease. The grease
fitting is easily accessible behind the V-belt
guard. Apply grease using a hand held
grease gun until the pin extends from the
pressure relief valve (located 180°from
grease fitting on the bearing). Wipe off
excess grease. Excess grease will attract
dirt.
• A grease fitting is on the end of the stub
shaft to grease the spline coupling. Apply 2
to 3 shots of grease approximately every
1000 hours of operation. Wipe off excess
grease. Excess grease will attract dirt.
DO NOT over grease, over greasing could
cause a hydraulic type lift on seals.
GREASE APPROXIMATELY EVERY
1000 HOURS OF OPERATION
PIN