Specifications

7500 SERVICING CUTTER WHEEL
38
TOOTH ARRANGEMENT
• Inspect pockets, teeth and bolts for damage
and replace as required.
• When replacing pockets, always replace
new pockets across from each other in
order to prevent vibration.
• Replacement teeth must be carbide tipped
and have like design as provided with the
machine.
•
Use anti-seize on threads to prevent bolts
from “freezing up” in cutter wheel pockets.
• When replacing complete set of teeth, be
sure to duplicate original factory tooth
arrangement.
• Torque bolts to 150 ft/lbs.
opposing outside pockets carry like arrangements of teeth to cancel vibration
• Straight teeth are mounted in TWO
OPPOSING OUTSIDE POCKETS.
• A straight tooth must have a 45° tooth
accompanying it in the same pocket set.
The opposite pocket sets should have this
same combination of straight and 45° teeth,
except with positions reversed. Mounting
these teeth opposite each other on the cutter
wheel cancels damaging vibration.
•
Two Remaining Outside Pockets must have
45° teeth overlapping centerline of wheel
to make plunge cuts possible. Mount two
left 45° teeth opposite two right 45° teeth.
• Inside pockets require 45° teeth mounted
away from the wheel.
• The second pocket in each group gradually
goes back into the cutter wheel for half a
rotation and then repeats.