Specifications

7500 SERVICING STUB SHAFT
65
• Replace any parts found defective or
worn. Put stub shaft coupling plate onto
the flywheel. The plate is attached using
eight 10MM-1.5 x 20MM bolts with a
lock washer. Put LocTite® 242 (blue)
on the end of the bolt and lightly tighten
all bolts. When all bolts have been
inserted and lightly tightened, torque all
bolts to 35 ft. lbs.
• Put anti-seize (coupling lubricant) on the
inside of the coupling. Line up external
splines with the coupling ID and slide
the stub shaft plate into place.
• Make sure the grease fitting is on the top
of the assembly. Replace the 10MM-1.5
x 30MM bolts and torque to 35 ft. lbs.
There are eleven bolts holding the plate
to the engine.
• Remove the grease fitting and replace
with the grease fitting extension supplied
with the machine.
GREASE
FITTING UP