Specifications

7500 SERVICING STUB SHAFT
66
• Bolt grease fitting to the air filter
bracket.
• Before starting the engine, apply grease
to the grease fitting until the pin on the
opposite side of the stub shaft pops out
(see Machine Maintenance section for
more information).
• Start replacing parts in the opposite
order in which they were removed.
Replace the V-belt guard and then
replace the engine and jackshaft pulleys.
Torque the bolts in the pulleys to 30 ft.
lbs. It will be easier to bolt the belt
keepers onto the stub shaft plate before
you put the engine pulley on.
• Replace the V-belt and align the pulleys
as instructed in the Servicing Belt
Section of the manual. Adjust pulleys as
necessary to get the proper belt
alignment. Check belt tension and set as
described in Servicing Belt section. Belt
alignment and tension are very important
for long bearing life.
DO NOT RUN MACHINE WITHOUT
ALL GUARDS IN PLACE AND
SECURED PROPERLY.