Specifications

SP8018 TRX SERVICING CUTTER WHEEL

SAFETY:

• DO NOT OPERATE MACHINE WITHOUT A FULL SET OF TEETH.

OPERATING MACHINE WITHOUT A FULL SET OF TEETH CAN CAUSE

EXCESSIVE VIBRATION AND PREMATURE BEARING FAILURE.

• NEVER ATTEMPT TO SERVICE MACHINE WITH ENGINE RUNNING.

• DO NOT SERVICE MACHINE UNTIL ALL MACHINE PARTS COOL

COMPLETELY.

• REMOVE KEY AND DISCONNECT BATTERY CABLE TO AVOID STARTING

MACHINE WHILE BEING SERVICED.

• CUTTER WHEEL MUST BE DISENGAGED.

• There are thirty-two (32) teeth to a

complete set on the model SP8018 TRX.

Two (2) straight teeth, fifteen (15) left

45° teeth and fifteen (15) right 45° teeth.

• A locking pin is provided to hold cutter

wheel in position during tooth removal

and re-installation.

• Locking pin will only lock on outer

teeth. NEVER PLACE HAND ON

CUTTER WHEEL TO HOLD IN

PLACE WHILE CHANGING

TEETH. BE SURE TO REMOVE

PIN BEFORE OPERATING.

• A Tooth Setting Gauge (P/N - 0450111)

is provided with each machine for proper

tooth installation. Line all teeth up with

the inside edge of the groove in the

gauge. Set ALL

teeth to this edge with

gauge against pocket, not against cutter

wheel. All teeth are set 1 1/4” out of the

pocket to the edge of the carbide.