Specifications

SP8018 TRX SERVICING HYDRAULICS
45
SAFETY
• NEVER SERVICE A MACHINE WITH THE ENGINE RUNNING, SEVERE
PERSONAL INJURY COULD OCCUR. TURN ENGINE OFF THEN REMOVE
IGNITION KEY AND DISCONNECT POSITIVE BATTERY CABLE TO AVOID
STARTING MACHINE ACCIDENTALLY.
• CUTTER WHEEL MUST BE DISENGAGED BEFORE TURNING ENGINE
ON/OFF AND BEFORE SERVICING A MACHINE. OTHERWISE SEVERE
PERSONAL INJURY COULD OCCUR AS WELL AS MACHINE DAMAGE.
• ALL MACHINE PARTS MUST COME TO A COMPLETE STOP AND HAVE
TIME TO COOL COMPLETELY BEFORE SERVICING A MACHINE OR
SEVERE INJURY COULD OCCUR, POSSIBLY SERIOUS BURNS AND/OR
DISMEMBERMENT.
• PLACE THE CUTTER WHEEL ON THE GROUND WHEN PERFORMING
SERVICE ON A MACHINE.
• RELEASE HYDRAULIC PRESSURE BEFORE PERFORMING ANY SERVICE
TO HYDRAULIC LINES OR OTHER COMPONENTS.
• FLUID UNDER PRESSURE CAN PENETRATE THE SKIN AND CAUSE SEVERE
INJURY. SEEK IMMEDIATE MEDICAL ATTENTION IF SKIN IS
PENETRATED. CHECK HOSES AND FITTINGS USING A BOARD OR
CARDBOARD; DO NOT USE HAND OR FINGER. ALWAYS WEAR EYE
PROTECTION.
HYDRAULIC OIL & FILTER
• Check hydraulic oil level daily, with
engine off and cool, and replenish as
necessary. A site glass is provided for
easy viewing. If oil can be seen in glass,
there is enough oil in the tank. Do not
fill the tank more than 7/8 full; operating
at high temperature will cause oil to
expand and spill over if tank is full.
Tank capacity is 9 gallons. Remember
to replace and tighten the cap.
• The machine is equipped with Citgo
AW32 hydraulic oil at time of
manufacture; use the same or equivalent.
• Drain and replace hydraulic oil at least
once a year, more often if oil is very
dark or smells burnt. Discard used oil
properly.