Specifications

SP8018 TRX SERVICING HYDRAULICS
47
REPLACING HYDRAULIC PUMP
• Engine must be shut off.
• Remove key & disconnect battery cable.
• Make sure that hydraulic oil is cool and
that pressure is relieved from the lines.
• Disconnect hydraulic lines from pump
and cap them, mark which line goes
where to reconnect correctly.
• Remove bolts holding pump to engine.
• Replace pump and tighten bolts.
• Uncap and reconnect hydraulic lines
paying attention to how they were
marked.
• Recheck oil supply in reservoir,
replenish if necessary.
HYDRAULIC HOSES & FITTINGS
• Inspect hydraulic hoses and fittings daily
for leaks, tightness, wear, or damage.
Repair or replace as needed.
• FLUID UNDER PRESSURE CAN
PENETRATE THE SKIN AND CAUSE
SEVERE INJURY. CHECK HOSES
AND FITTINGS USING A BOARD
OR CARDBOARD; DO NOT USE
HAND OR FINGER. SEEK
IMMEDIATE MEDICAL ATTENTION
IF SKIN IS PENETRATED. ALWAYS
WEAR EYE PROTECTION.