Installation guide

13
Inverter Installation
Option 1: Plug & Power
Plug & Power is the easiest way to install Go Power! Inverters. Your inverter should be
located close to the batteries, but in a protected area free from moisture, dust, dirt and
battery fumes. The DC Install Kits listed on page 10 contain everything you need to install
your inverter properly. Once installed, simply plug your power cord into your Go Power!
Inverter and you will have AC power.
Overview
• Inverter installed near batteries (<10’ away)
• Plug shore power cord into:
• inverter when camping
• shore outlet when available
• Turn off converter when using inverter to prevent extra battery drain
Option 2: Go Power! Hardwire with standard
Automatic Transfer Switch
Use the TS-30 automatic transfer switch with your Go Power! Inverter to automatically
switch from shore power (when available) to inverter power. Wire your converter to the
shore power side of the transfer switch to ensure the inverter is not being used to charge
the RV batteries.
Overview
• Inverter installed near batteries (<10’ away)
• TS-30 is wired to shore power, inverter and RV load centre
• Converter or battery chargers wired to TS-30 shore input to prevent extra
battery drain when inverter is being used
Option 3: Go Power! Hardwire with Go Power!
Prewired Automatic Transfer Switch
The Go Power! Inverter and the Go Power! Transfer Switch (GP-TS) combined with a GPC
Converter/Charger creates a totally hands-free system. Add a GPC-Smart Controller and
take advantage of high powered three-stage smart charging capabilities.
Overview
• GP-TS is wired to shore power, RV load centre and plugs directly into inverter
• GPC Converter plugs into outlet on GP-TS. Converter automatically turns off
when using inverter power
Note: See inverter manuals for complete instructions prior to installation.
Connect the inverter to batteries
(using Go Power! DC Install Kits).
Install fuse on positive cable within
2 feet of battery positive terminal.
Plug RV power cord into inverter for
AC power in RV.
Connect the inverter to batteries
(using Go Power! DC Install Kits).
Install fuse on positive cable within
2 feet of battery positive terminal.
Power cord and inverter are wired to the breaker
panel via TS-30. The stock converter charger must
be disconnected from the AC breaker panel and
be installed with a 15 amp fuse to the TS-30 shore
power input.
Connect the inverter to batteries
(using Go Power! DC Install Kits).
Install fuse on positive cable within
2 feet of battery positive terminal.
Power cord and inverter are wired to the breaker
panel via GP-TS. Battery charger or stock
converter is plugged into the GP-TS. Now the
system is
fully automatic!