Operation Manual

ManualsBrandsCarmen ManualsElectric blanketEB2000

17•English

› Use in accordance with purpose

The appliance is only intended for (pre)heating your bed. Use only

as an underblanket and do not use above the occupant of the bed.

No liability is accepted for any damage resulting from use for other

purposes, faulty operation or amateur repairs. Guarantee services

arealsoexcludedinsuchcases.

The appliance is not intended for medical use in hospitals!

› Operating instructions model EB0500

Switchcontrol(A)

1. Heat levels 3 and 4

2. Heat levels 1 and 2

3. Braille markings

4.Oposition

How to use switch

1. Ensure the blanket is tted to the bed correctly.

2.Plugthepowerleadintotheclosestsocket,usinganextension

lead if needed to ensure that the lead is not stretched.

Preheating the bed

Move the heat setting on the control switch to heat level 3 or 4,

dependingontheleveloftheheatrequired.Allowapproxima-

tely 60-90 minutes for the blanket to heat the bed thoroughly,

although this time may vary depending on the room temperature

and type of bedding used.

All night use

Move the heat setting on the control switch to heat level 1 or 2.

• Thesesettingswillprovidesafeandcomfortableheattosleep

on all night.

• Thesesettingscanalsobeusedtoairthebed.

Warning!

Always ensure that the heat setting is moved to the OFF position

whenyougetupthenextday,orafterairingthebed.

Braille markings

• Braillemarkingsarelocatedonthebackoftheswitchtohelp

identify the direction of the heat level in the dark, or if visually

impaired.

• Thehighestheatlevel‘preheat’isidentiedby3raisednodu-

les,‘midlevel’by2raisednodulesand‘lowlevel’(allnight)by

1 raised nodule Fitting underblanket.

Fitting instructions

1. Place the blanket directly on the mattress, with the control

switch end at the head of the bed (D).

2. The blanket must be positioned to the mattress in the following

manner. Place the blanket directly on the mattress and ensure

that a space of 10-15cm (4-6 inches) is left between the bottom

edge of the blanket and mattress.

3. Position the blanket on the bed ensuring the pillow area is clear.

› Operating instructions model EB1000

Switchcontrol(B)

1. Illuminated heat setting light

2. Heat levels 3 and 4

3. Heat level 1 and 2

4. Braille markings

5.Oposition