Experiment Manual Hydropower Manual.
Kit Contents No. Name Quantity Part No.
Table of Contents 25 8 9 10 11 13 A Word to Parents. . . . . . . . . . . . . inside front cover Safety Information. . . . . . . . . . . . . inside front cover Kit Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 The Story of Hydropower . . . . . . . . . . . . . . . . . . . . . 4 Your First Water Wheel. . . . . . . . . . . . . . . . . . . . . . . 6 Hydropower Sawmill . . . . . . . . . . . . . . . . . . . . . . . . . 8 The Surface Tension of Water . . . . . . . . . . . . . . . .
Hydropower Sawmill 02 Workshop Sawmill You will need: 1 water inlet (plastic sheet) 2 water wheel disks (plastic sheet) 12 water wheel paddles (plastic sheet) 1 plastic strip to make a ring (plastic sheet) 4 large gear wheels (16) 3 small gear wheels (15) 1 long axle (19) 1 medium axle (18) 2 large frames (14) 2 small frames (13) 1 short rod (10) 4 long rods (11) 4 5-hole rods (9) 2 3-hole rods (8) 1 washer (6) 2 shaft plugs (2) 1 shaft pin (3) 1 joint pin (1) 19 anchor pins (4) Separate the water inlet s
You can pull the assembled water wheel off the axle and stick it back on again. You may have to do this if the paddle direction is wrong. b When removing the water wheel, press the two gear wheels tightly together so that the paddles don’t fall out. Then carefully remove the axle. Be careful not to twist the water wheel disks and gears, or to crush them. If the water wheel falls apart, you will have to reassemble it with the instructions on page 6. b 9 Hydropower Manual.