Dimensions Guide

ASSEMBLY AND OPERATING INSTRUCTIONS

HARDWARE LIST

(A) (B) (C) (D) (E)

Hex

Nylock

Nut

qty-4

Lock

Washer

qty-4

Hex

Bolt

qty-4

Cotterless

qty-4

Top

Belt

qty-1

(F)

Receiver Bar

qty-1

Patent Pending

. Make sure all hardware connections are secure before each use.

. Never exceed receiver hitch manufacturer’s tongue weight rating.

. Do NOT allow exhaust fumes to blow on loaded cargo – It’s a re

hazard.

. Never exceed maximum static BASE LOAD capacity of 450 Lbs.

(evenly distributed).

. Do NOT transport ammable items such as gas, propane, etc.

. Carpod is not intended for transporting humans or live stock.

. Never exceed maximum SIDEWALL pressure load of 150 Lbs. (evenly

distributed).

. Never load cargo on top of the sidewalls in folded position.

. Bouncing or rapid stopping of the vehicle will increase the load

weight and may reduce rated capacity substantially.

. Accessory tail light kit must be used if Cargo Carrier covers vehicle

taillights.

. When erecting/opening sidewalls DO NOT release them to free-fall.

. CARPOD Inc. will NOT be responsible for any damage if warnings

have not been heeded.

Contain Your Cargo

Sherman Oaks CA 91411

PAGE 1
Contain Your Cargo ASSEMBLY AND OPERATING INSTRUCTIONS . Make sure all hardware connections are secure before each use. . Never exceed receiver hitch manufacturer’s tongue weight rating. . Do NOT allow exhaust fumes to blow on loaded cargo – It’s a fire hazard. . Never exceed maximum static BASE LOAD capacity of 450 Lbs. (evenly distributed). . Do NOT transport flammable items such as gas, propane, etc. . Carpod is not intended for transporting humans or live stock. .
PAGE 2
IMPORTANT NOTICE C G F B A G 1) Insert the Receiver Bar (F) into the carrier’s Angle Plate (G) from the opposite end of the CARPOD® sticker. 2) Align the carrier Angle Plate holes with the Receiver Bar holes. 3) Insert the four Hex Bolts (C) through the carrier Angle Plate and the Receiver Bar. 4) Slide the Lock washer (B) over the Hex Bolt. 5) Place the Hex Nylock Nut (A) on Hex Bolts (C) and tighten. If exhaust heat blows directly onto cargo, position load away from it.