Specifications

Chapter 4 4-Wire E&M/TO Configuration
4-12
ASSEMBLY INSTRUCTIONS
See below for wiring information. The cable must exit the DIN connector housing from the right side
(when viewed from the top). During assembly, a 1.5” piece of red heat shrinkable tubing is to be shrunk
around each cable where it enters the Telco connector in order to distinguish this cable from other CAC
cables.
Physical Appearance
C-Type 96 Pin DIN Connector
Housing must be side entry
type. Cable enters from right
side (when viewed from top).
50-Pin AMP Champ
Connectors, male side in
housing.
50 Conductor, Solid Strand,
24AWG
A
B
Red Shrinkable Tubing
Figure 5-7 E&M Normal Mode Cable